;">Dial diameter: 60100150;
,1.5;">The accuracy level: (1, 1.5); ;">Thermal response time: less than 40S; ;">Protection grade: IP55;Angle adjusting error: angle adjustment error should not exceed the range of 1%; ;">Return difference: double metal thermometer to the difference should be less than the absolute value of the basic error limit; 。">Repeatability: double metal thermometer repeatability limit should be less than the absolute value of basic error of 1/2.Six, matters needing attention:
、在保管 、安裝、使用及運輸過程中
,盡量避免碰撞保護管
,禁止讓保護管彎曲、變形
。">1, in storage, installation, use and transport process, to avoid the collision protection tube, prohibit the protection tube bending and deformation.
、安裝時,嚴禁扭動儀表外殼 。">2, installation, non twist instrument shell.
、儀表應在-30℃~80℃的環境溫度內正常工作。">3, the instrument shall work normally in the -30 to 80 DEG C ambient temperature. 、儀表經常工作的溫度能在刻度范圍的1/2~3/4處。">4, the instrument can often work in the temperature scale range 1/2 ~ 3/4.
、保護管浸入被測介質中長度須***大于感溫元件的長度,這樣做是為了保證測量的準確性。">5, the protective tube immersionmedium measured in length must be greater than the length of the sensing element, this is done in order to ensure the accuracy of measurement.
。">6, do not use media exposure in measuring container.、使用過程中要注意檢查,時間大概在在6個月左右。">7, the use of the process should pay attention to check in time, probably in about 6 months.
、測溫范圍:">Seven, temperature range:The measuring range of C | Applicable scope |
Industrial and commercial | 、小型">Laboratory and small |
-80 ~ +40 | B. | B. |
-40 ~ +80 | B. | B. |
0 ~ 50 | B. | B. |
0~100 | B. | B. |
0~150 | B. | B. |
0~200 | B. | B. |
0 ~ 300 | B. | B. |
0~400 | B. | B. |
0~500 | B. | B. |
、外形尺寸:">Eight, dimensions:form | D | A | B | E | D |
Radial type | One hundred and five | Twenty-three | Seventy-three |
| With 8 With 10 |
One hundred and fifty-five | Twenty-three | Seventy-three |
|
Axial type | Sixty-five | Fifty | One hundred and ten | Thirty-four |
One hundred and five | Fifty | One hundred and ten | Thirty-four |
Universal type | One hundred and five | Twenty-three | One hundred and seventy-eight | One hundred and twenty |
One hundred and fifty-five | Twenty-three | One hundred and seventy-eight | One hundred and twenty |
Electric contact Axial type | One hundred and twenty-eight | Forty | One hundred and thirty-five |
|
Electric contact Radial type | One hundred and twenty-eight | Seventy-two | One hundred and fifty | Forty-two |
Electric contact Universal type | One hundred and twenty-eight | Forty | One hundred and seventy-five | Ninety-eight |
9, models and specifications:
Model | The measuring range of C | Precision grade | Protection tube material | Specifications | Mounting device |
WSSB-410 | -80-+40 -40-+80 0-50 0-100 0-150 0-200 0-300 0-400 0-500 | One point five | 1Cr18NI9Ti Three hundred and four Three hundred and sixteen 316L Hastelloy C-276 H.AIIoyc-276 | Seventy-five One hundred One hundred and fifty Two hundred Three hundred Four hundred Five hundred Seven hundred and fifty One thousand | No screw fixing device |
WSSB-480 |
WSSB-411 | Movable external thread |
WSSB-481 |
WSSB-412 | The movable internal thread |
WSSB-482 |
WSSB-413 | Fixed flange |
WSSB-483 |
WSSB-414 | Fixed thread |
WSSB-484 |
WSSB-415 | Card set screw |
WSSB-485 |
WSSB-416 | Sleeve flange |
WSSB-486 |
,位式調節上下限,測溫范圍">Example: Zhongwei flameproof universal type double metal thermometer, a regulating upper temperature range Zero ~Four hundred C, protective tube Three hundred and sixteen ,插入長度">Insert, length
300mm WSSX-481BM 0 ~ Four hundred C L=300Protection tube Three hundred and sixteen 。">.
Ten, the selection of encoding:
Serial number | category | Specifications | Explain |
WSS | B | Explosion proof type | Double metal thermometer (Zhongwei control) |
Dial diameter | -3 |
| Phi 60 |
-4 |
| Phi 100 |
-5 |
| Phi 150 |
Dial form | Zero |
| The axial (straight) |
One |
| Radial (angle) |
Two |
| 135 degrees to (an obtuse type) |
Eight |
| Universal (angle adjustable type) |
Fixed form | Zero |
| No fixed device |
One |
| Movable external thread |
Two |
| The movable internal thread |
Three |
| Fixed thread |
Four |
| Fixed flange |
Five |
| Card set screw |
Six |
| Sleeve flange |
Type of protection | - |
| Ordinary type |
W |
| Type of protection |
F |
| Anti-corrosion type |
、">Eleven,
Design selection and ordering information: 、型號;">1, model;
、精度等級